How much oil does a 2013 Honda CRZ 1.5 take?
The 2013 Honda CR-Z with the 1.5-liter engine requires about 3.7 quarts (3.5 liters) of engine oil for a full change with a new filter. This figure is the official capacity for a standard oil-and-filter service, but always verify against your owner's manual and VIN, and check the level with the dipstick after refilling.
Key figures and guidelines
According to Honda’s maintenance data for this model, the engine oil capacity refers to a complete change with a new filter. The recommended viscosity and details can vary by climate, so consult the manual for your specific market. The following points summarize the core figures you’ll use in practice.
- Capacity (with a new filter): 3.7 quarts (3.5 liters).
- Recommended oil grade: 0W-20 is commonly specified for the 1.5-liter engine; some markets may approve 5W-20, so verify in your manual.
- Oil filter: Replace at every oil change with a genuine or high-quality compatible filter.
- Verification: After filling, run the engine briefly, then recheck the level with the dipstick to ensure it sits within the full mark when the oil is warm.
Concluding note: The above figures reflect a standard oil-and-filter change. Individual vehicles can vary slightly due to engine condition, drain time, or filter choices, so always confirm with the dipstick after service.
Step-by-step: performing an oil change
To ensure you use the right amount and avoid overfilling, follow these practical steps during an oil change.
- Warm the engine briefly to help drainage, then turn off and let it sit so the oil can pool in the pan.
- Place a drain pan under the drain plug, remove the plug, and allow the old oil to drain completely.
- Remove and discard the old oil filter; lightly oil the gasket on the new filter before installing it.
- Install the new filter and begin adding oil. Start with about 3.7 quarts (3.5 liters) and stop to check the level with the dipstick as you add more.
- Start the engine, run for a minute, turn off, and then recheck the oil level. Top up if needed to reach the full mark when the oil is warm.
Concluding note: Following these steps, tied to the official 3.7-quart capacity, helps ensure proper lubrication and prevents overfill.
Notes and caveats
Always refer to the owner’s manual for your exact vehicle configuration, as oil capacity and viscosity recommendations can vary by market, trim, and climate. If you’re unsure, consult a qualified technician or Honda service center.
Summary
For a 2013 Honda CR-Z with a 1.5-liter engine, plan for about 3.7 quarts (3.5 liters) of engine oil during a full oil change with a new filter, using the recommended viscosity (typically 0W-20). Verify the level with the dipstick after filling and consult the manual for your specific vehicle to account for any variations.
