How much oil does a 2015 Crosstour 3.5 take?
The engine oil capacity for the 2015 Honda Crosstour with the 3.5-liter V6 is about 5.7 quarts (5.4 liters) when performing a full oil change with a new filter. If you only top off without changing the filter, the system holds roughly 5.0 quarts.
This figure comes from Honda’s service information for the J-series 3.5L engine used in the Crosstour. Exact capacity can vary slightly depending on the specific oil filter, drain method, and whether you are replacing the filter during the change. Always verify with the owner’s manual or the oil cap label, and use the recommended viscosity for your climate (typically 0W-20 synthetic in many regions; 5W-20 is also specified in some markets).
Oil capacity and specifications
Below are the standard figures and notes you should consider when planning an oil change for the 2015 Crosstour 3.5:
- Engine oil capacity with filter: 5.7 quarts (5.4 liters)
- Engine oil capacity without filter: approximately 5.0 quarts
- Recommended oil grade: 0W-20 synthetic (check your manual for local recommendations; some markets may use 5W-20)
- Oil type guidance: Full synthetic is preferred for the 3.5L V6 for optimal protection and performance
When performing an oil change, use the “with filter” capacity as your target and confirm the final level with the dipstick after topping off. Avoid overfilling, which can lead to excessive pressure and leaks.
Step-by-step oil-change procedure
If you’re planning to do the oil change yourself, here’s a concise, standard procedure to follow. Always consult the owner’s manual for any model-specific instructions.
- Warm the engine to operating temperature for better drainage.
- Park on level ground, engage the parking brake, and turn off the engine.
- Raise the vehicle securely and place a drain pan beneath the oil pan.
- Remove the drain plug and allow the old oil to drain completely.
- Remove the old oil filter and replace it with a new one; lubricate the gasket of the new filter with a bit of fresh oil.
- Install the drain plug firmly after draining, then lower the car.
- Fill with the recommended amount of oil (5.7 quarts with filter) using the correct grade (0W-20 synthetic in most regions).
- Check the oil level with the dipstick; add small amounts if needed to reach the full mark.
- Start the engine, run it briefly, then re-check for leaks and verify the level again; reset maintenance indicators if applicable.
If you’re not comfortable performing an oil change yourself, have a professional complete the service to ensure the correct capacity and filter installation.
Notes and sources
Always refer to your vehicle’s owner’s manual or the oil-filler cap for the most accurate, model-specific specifications. Honda’s official service information for the 3.5L J-series engine used in the 2015 Crosstour lists 5.7 quarts with filter as the standard capacity and emphasizes using the recommended viscosity for your climate and driving conditions.
Summary
The 2015 Crosstour 3.5 takes about 5.7 quarts of engine oil when performing a complete oil change with a new filter (roughly 5.4 liters). If you do not replace the filter, expect around 5.0 quarts. Use the recommended oil grade (commonly 0W-20 synthetic in many regions), verify the level with the dipstick after filling, and consult the owner’s manual for any region-specific requirements. Regular maintenance keeps the 3.5L V6 running smoothly and helps protect engine longevity.
How much oil does a 2015 Honda Crosstour 3.5 take?
Notes: Full synthetic Dexos. 0W-20. 5 quart.
How much oil does a 2015 3.5 take?
6.3 quarts
The Third engine option in the 2015 F-150 is the standard 3.5L Ti-VCT, which will take a bit more fluid than its EcoBoost counterparts. This 3.5L engine has a capacity for 6.3 quarts of engine oil, or 6 total liters. How much Oil does the 2015 F-150 V8 Engine Need?
Can I put 5W-30 instead of 5W-20 on a Honda Accord?
You can likely use 5W-30 instead of 5W-20 in your Honda Accord, but you should check your owner's manual first, as the recommended oil can vary by model year and engine. Using a slightly thicker oil is sometimes done for older or high-mileage engines, but it may slightly decrease fuel economy, as the lighter 5W-20 is often specified for better efficiency.
Potential effects of using 5W-30
- Fuel economy: Thicker oil requires more energy to pump, which can lead to a slight reduction in gas mileage.
- Engine performance: Engineers design engines for specific oil viscosities. Sticking to the recommended 5W-20 ensures optimal performance and protection according to the manufacturer's specifications.
- Engine wear: In some cases, using a heavier oil in a high-mileage engine might be beneficial, especially if you're experiencing oil consumption issues. Some mechanics recommend a 5W-30 in older Honda engines to help with this, but it can also increase engine friction if the engine wasn't designed for it.
What to do
- Check your owner's manual: The most important step is to consult your car's owner's manual for the exact oil viscosity recommendation for your specific model and engine.
- Consult a mechanic: If you're concerned about your engine's performance or have a high-mileage vehicle, a mechanic can provide advice tailored to your car's condition.
How many quarts of oil does a Honda Crosstour take?
The oil capacity for a Honda Crosstour depends on the engine. For the 4-cylinder engine, it is 4.5 quarts (with filter). For the 6-cylinder engine, it is also 4.5 quarts with a filter, or 4.2 quarts without a filter. Always check your owner's manual for the exact amount needed for your specific model and engine.
- 4-Cylinder Engine: 4.5 quarts with filter.
- 6-Cylinder Engine: 4.5 quarts with filter, 4.2 quarts without filter.
