How much oil does a 2016 Toyota Camry take?
The 2016 Toyota Camry’s oil capacity depends on the engine installed. The 2.5-liter four-cylinder models take about 4.8 quarts of oil with a filter, while the 3.5-liter V6 models require about 6.4 quarts with a filter. Toyota also specifies 0W-20 full-synthetic oil for these engines. The hybrid version shares the smaller engine’s capacity, typically around the same 4.8-quart figure.
Engine options and their oil needs
2.5-liter four-cylinder (2AR-FE)
The 2.5L engine is the most common in 2016 Camrys, powering most LE and SE trims. It has a comparatively modest oil demand compared with the V6.
Oil capacity for this engine
- 4.8 quarts (approximately 4.6 liters) of oil, including the new filter
In practice, plan to start with about five quarts during a full oil change with a new filter, then top off to reach the correct level on the dipstick.
3.5-liter V6 (2GR-FE)
The larger V6 is found in higher-trim models (such as XLE/XSE) and delivers more power, at the cost of greater oil volume.
Oil capacity for this engine
- 6.4 quarts (approximately 6.0 liters) of oil, including the new filter
During a full oil change, expect to drain and replace about six and a half quarts, then adjust to the dipstick level as needed.
Oil type, interval, and practical tips
For both engines, Toyota recommends 0W-20 full-synthetic oil in most regions. Always consult the owner's manual or your local dealer for the exact maintenance interval, but typical guidance ranges from about 5,000 miles with conventional oil to roughly 10,000 miles (or 12 months) with synthetic oil, depending on driving conditions.
How to check and refill oil safely
To check or add oil, park on a level surface and let the engine cool. Use the dipstick to verify the current level, then add oil in small increments, rechecking after each addition to avoid overfilling. After adding, run the engine briefly to circulate the new oil, then perform a final dipstick check.
Summary
Bottom line: The 2016 Camry’s oil capacity depends on the engine choice—about 4.8 quarts for the 2.5L four-cylinder and about 6.4 quarts for the 3.5L V6—with 0W-20 full-synthetic oil recommended. Always verify the exact specification in the owner’s manual and follow the official maintenance schedule for your vehicle’s configuration.
