How much oil does a 5.0 Coyote engine take?
The typical capacity is about 7 quarts (roughly 6.6 liters) of engine oil with the filter installed, and about 6 quarts (roughly 5.7 liters) if the filter isn’t replaced. Always check your vehicle’s manual and use the dipstick to confirm for your year and model.
Oil capacity at a glance
For most 5.0 Coyote engines used in popular applications such as the Mustang GT and F-150, the following figures apply during a standard oil change.
- With the factory oil filter installed: about 7 quarts (approximately 6.6 L).
- Without replacing the filter: about 6 quarts (approximately 5.7 L).
Note that some variants or service updates may present slight deviations. Always verify the exact specification in the owner’s manual or a dealership service bulletin for your specific vehicle.
Context and caveats
Oil capacity can vary by model year, engine variant, and sump design. The 5.0 Coyote has evolved through generations, but in most consumer configurations it uses a wet-sump lubrication system with a capacity that centers around the 7-quart mark when a filter is present.
Generation notes
- Early and mid-generation 5.0 Coyotes commonly align with a 7-quart fill with filter.
- Later or specialty editions generally follow the same rough capacity, though exact figures should be confirmed in the manual.
For precise guidance, always refer to your vehicle’s owner’s manual and confirm the recommended oil type and capacity for your specific year and model.
How to approach an oil change
If you’re performing an oil change yourself, follow these steps to ensure you reach the correct level without overfilling.
- Warm the engine to operating temperature to get an accurate dipstick reading.
- Drain the old oil completely and replace the oil filter with a suitable, manufacturer-approved part.
- Add oil gradually, starting near the lower end of the specified range, then recheck with the dipstick.
- Run the engine briefly, turn off, wait a few minutes, and recheck the level. Top off if needed to reach the full mark.
Bottom line: for most 5.0 Coyote engines, plan for about 7 quarts with a new filter, and about 6 quarts if you’re not changing the filter. Always verify with the manual and your dipstick after filling.
Summary
The Ford 5.0 Coyote generally requires around 7 quarts (6.6 L) of oil with the filter installed, and about 6 quarts (5.7 L) without changing the filter. Exact figures can vary by year and variant, so always consult the owner’s manual and confirm the level with the dipstick after filling. Regular maintenance with the correct oil specification helps keep this modern V8 performing at its best.
How many quarts oil does a 2018 F150 5.0 use?
The oil capacity for a 2018 F-150 with the 5.0L engine is 8.8 quarts (8.3 liters) with a filter change. It's important to always check the oil level after refilling and to use the correct oil, which is SAE 5W-20.
- Capacity: 8.8 quarts (8.3 liters) with filter
- Recommended Oil: SAE 5W-20
- Verification: Always check the dipstick after filling and before driving to ensure the oil is at the correct level.
Is it normal for a coyote 5.0 to have a lot of metal in the oil?
Sources of Metal Flakes in Oil
This is a part of normal engine wear. The oil filter is responsible for catching metal flakes. This is why it's key to check and replace the oil and the oil filter on a regular basis.
How much oil does a 5.0 coyote take?
A 5.0L Coyote engine typically requires between 7.7 and 10 quarts of oil, depending on the model year and vehicle. For example, F-150s from 2011-2017 generally take 7.7 quarts, while newer 2018+ Mustang GTs require 10 quarts. Always check your specific owner's manual for the exact capacity.
| Vehicle | Approximate Oil Capacity |
|---|---|
| 2011-2017 F-150 | 7.7 quarts |
| 2015-2017 Mustang GT | 8 quarts |
| 2018+ Mustang GT | 10 quarts |
| 2018+ F-150 | 8.8 quarts |
(this||self).Wufxzb=function(c,e,f,l,k){var d=document.getElementById(c);if(d&&(d.offsetWidth!==0||d.offsetHeight!==0)){c=d.querySelector("div");var g=c.scrollWidth-c.offsetWidth,h=Math.min(e?g:0,g);c.scrollLeft=e&&(l||f)?0:h;var a=d.getElementsByTagName("g-left-button")[0],b=d.getElementsByTagName("g-right-button")[0];a&&b&&(e=RegExp("\\btHT0l\\b"),f=RegExp("\\bpQXcHc\\b"),a.className=a.className.replace(e,""),b.className=b.className.replace(e,""),h===0?a.className="pQXcHc "+a.className:(a.className=
a.className.replace(f,""),k&&c.classList.add("pA30Ne")),h===g?b.className="pQXcHc "+b.className:(b.className=b.className.replace(f,""),k&&c.classList.add("FpCCub")),setTimeout(function(){a.className+=" tHT0l";b.className+=" tHT0l"},50))}};}).call(this);(function(){var id='_z9olaeC_E9Ti7_UPmqqimAQ_242';var rtl=false;var gecko=false;var edge=false;var soh=false;
(this||self).Wufxzb(id,rtl,gecko,edge,soh);})();
How many quarts of oil does a coyote take?
The oil capacity for a Coyote engine depends on the vehicle and generation: 8 quarts for 2015-2017 Mustang GTs, 10 quarts for 2018+ Mustang GTs, and ~8.8 quarts for 2011-2017 F-150s. Always check your owner's manual or the dipstick for the most accurate capacity for your specific vehicle.
Mustang GT
- Gen 2 (2015-2017): 8.0 quarts
- Gen 3 (2018-2023): 10.0 quarts
- Gen 4 (2024+): 10.0 quarts
F-150
- 2011-2017: Approximately 8.8 quarts
- 2018+: 8.8 quarts
- 2020+: 7.75 quarts
