How much oil does a Ford Focus 1.5 TDCi take?
In most Ford Focus 1.5 TDCi applications, the engine oil capacity for a standard change with a new filter is about 4.0–4.2 liters (roughly 4.2 quarts). The exact amount can vary slightly by model year and variant, so it’s best to confirm with the owner's manual or Ford technical data for your specific car.
Oil capacity by engine variant
Ford has used multiple 1.5 TDCi variants over the Focus’ production span, notably the older Duratorq 1.5 TDCi and the newer EcoBlue 1.5 TDCi. While the capacity remains broadly similar, small differences exist between these variants. The figures below reflect typical, widely cited values for a full oil change with a new filter.
- Duratorq 1.5 TDCi (older generation): approximately 4.0 liters with the oil filter replaced.
- EcoBlue 1.5 TDCi (latest generation): approximately 4.2 liters with the oil filter replaced.
These figures are intended as practical guidelines. For the exact specification on your car, consult the owner’s manual or a Ford dealer, especially if your Focus is a special-market variant or has an unusual service history.
Oil grade and servicing guidelines
Choosing the right oil and staying on schedule is essential for diesel engines like the 1.5 TDCi. The guidance below reflects common Ford recommendations, though climate and driving conditions can affect the exact choice and interval.
- Oil grade: Use a synthetic engine oil that meets Ford’s specifications for your engine (often 5W-30 in many markets). Always verify the exact specification in your manual or with a dealer.
- Servicing interval: Diesel engines typically require oil changes at regular intervals (commonly around 12 months or 10,000–20,000 miles/km, depending on climate and driving). Follow the official Ford service schedule for your vehicle.
- Oil filter: Replace the oil filter with every oil change, as recommended by Ford. The filter helps ensure contaminants are removed and oil stays clean.
Following the correct oil grade and change interval helps protect the engine’s longevity and performance. If you frequently drive in extreme temperatures, heavy traffic, or short trips, more frequent changes may be advisable.
How to check oil level and top up safely
Accurate oil level checks are essential after an oil change. Use the dipstick procedure outlined below to ensure you add only what your engine needs.
- Park on level ground and engine off. Allow the engine to cool for several minutes so the oil settles.
- Remove the dipstick, wipe it clean, reinsert fully, then remove to read the level.
- If the level is below the minimum mark, add small amounts of the recommended oil, rechecking after each addition until the level sits between the minimum and maximum marks.
- Don’t overfill. Too much oil can create pressure and foam, which can harm engine components.
- After topping up, recheck the level once more and replace the dipstick securely.
Tip: Keep a bottle of the same oil you use for your next top-up in the boot so you can quickly address any minor losses between services. When in doubt, consult a qualified technician or Ford service center.
Summary
The Ford Focus 1.5 TDCi typically requires about 4.0–4.2 liters of engine oil for a full change with a new filter, with only minor variation by engine variant and market. Use the recommended synthetic oil grade and follow Ford’s service intervals. Always verify the exact specification for your vehicle in the owner’s manual or at a Ford dealership, and perform regular dipstick checks to ensure your engine stays properly lubricated.
What kind of oil does a 2017 Ford Focus 1.5 Tdci take?
0W-30
FOR FORD FOCUS TDCI ST-LINE 1.5 SERVICE KIT & 5L FORD OIL 0W-30 2017-2018.
How much oil does a Ford Focus 1.5 diesel take?
Capacities and Specifications - 1.5L Duratorq-TDCi Diesel
| Item | Capacity |
|---|---|
| Engine oil fill capacity including the oil filter. | 1.0 gal (3.8 L) |
| Engine oil fill capacity excluding the oil filter. | 0.9 gal (3.5 L) |
| Engine coolant fill capacity. | 1.9 gal (7.3 L) |
| Fuel tank fill capacity. | 15.9 gal (60 L) |
How much oil does a 1.5 DCI engine take?
The quantity needed to change the oil in your engine is 4,6 litres.
What kind of oil does a 1.5 Tdci take?
Adding oil: If you are unable to find an oil that meets the specification defined by WSS-M2C950-A, you must use SAE 0W-30 oil that meets the specification defined by ACEA A5/B5.
