What is the recommended tire pressure for an Acura Integra?

The recommended tire pressure is the cold inflation pressure shown on the driver’s door jamb placard, not the pressure after driving. For most Acura Integra models, this figure sits in the low-to-mid 30s psi for both front and rear tires; however, you should verify the exact value for your year, trim, and tire size in the owner's manual or on the placard.

Where to find the official spec

To ensure you inflate to the correct level, rely on the vehicle’s official labeling and documentation. The precise value can vary by trim and market, so consult the exact figures for your car.

• Driver's door jamb placard: shows the recommended cold tire pressures for the front and rear tires as installed on your car.


• Owner's manual tire information section: explains cold pressure requirements and how to interpret the numbers.


• Tire information label in the trunk or glove box (if present): some vehicles carry an additional label listing inflation ranges for different tire sizes or load conditions.

Using these sources ensures you inflate to the exact specification for your Integra's tire size and load scenario.

How to check and set your Integra's tire pressure

Follow these steps to ensure you inflate to the official spec and keep tires properly inflated for performance and safety:

1. Check that the vehicle is cold—ideally the car hasn't been driven for several hours. If the tires are warm, measurements may read higher than the cold spec.


2. Use a reliable tire pressure gauge (digital or analog) for an accurate reading.


3. Locate the correct cold pressure value for your tires on the placard or manual. Inflate or deflate each tire to that spec, starting with the front tires, then the rear tires.


4. Recheck all four tires after inflating to the specified pressure to confirm consistency.


5. Inspect tires for wear or damage while you check; unusual wear can indicate misalignment, suspension issues, or incorrect pressures.


6. Recheck periodically—tire pressure can change with temperature, altitude, or wheel swaps, so measure again after a few weeks or after changing load conditions.

Maintaining the correct cold pressure helps optimize grip, fuel economy, and tire longevity while reducing the risk of uneven wear or blowouts.

Special considerations for load, weather, and tire type

Tire pressure can vary with load, weather, and the type of tire installed. Consider these guidelines beyond the base spec:

• Heavier loads or frequent full loads may require slight adjustments from the base spec as indicated by the placard.


• Temperature changes affect pressure; roughly 1 psi change for every 10°F (about 6°C) is a common rule of thumb.


• Winter tires, summer performance tires, or run-flat tires may have different recommended pressures; always follow both the vehicle spec and tire manufacturer guidance.

When in doubt, default to the vehicle's official spec and consult a dealer or tire professional for model-specific adjustments.

Summary

The Acura Integra's tire pressures are defined by the cold-inflation specification on the driver's door jamb placard and explained in the owner's manual. Always verify the exact numbers for your year, trim, and tire size, and maintain equal pressures across all four tires. Regular checks support safe handling, better ride quality, and longer tire life.

Should I use 32 or 35 tire pressure?

For most cars, the recommended tire pressure is between 32 and 35 psi, and you should use the pressure listed on the driver's side door jamb or in the owner's manual. The correct pressure can vary by vehicle, and the pressure on the tire's sidewall is a maximum, not the recommended value. Using the correct pressure ensures proper handling, fuel efficiency, and tire life, while using the wrong pressure can cause poor handling, reduced traction, and premature wear.
 
How to find the right pressure

• Check the sticker on the driver's side door jamb. This is the most reliable source for your specific vehicle. 
• Consult your owner's manual for the manufacturer's recommendation. 
• Note that the pressure should be checked when the tires are cold (before driving). 
• Don't use the pressure listed on the tire's sidewall, as this is the maximum pressure the tire can hold, not the recommended pressure for your car. 

Why the correct pressure is important

• Too low: Can lead to poor fuel economy, premature tire wear, and a higher risk of tire failure. 
• Too high: Can cause reduced traction, an uncomfortable ride, and rapid, uneven tire wear. 
• Correct pressure: Optimizes handling, safety, and fuel efficiency, and helps your tires last longer. 

What should Acura Integra tire pressure be?

around 32-35 pounds per square inch
Finding Your Acura Model's Recommended Tire Pressure
Most Acura vehicles have a recommended tire pressure of around 32-35 pounds per square inch (PSI). For a specific tire pressure number for your Acura vehicle, consult your owner's manual or the sticker that should be on the door frame of the driver's side door.

Is 35 PSI for tires too high?

No, 35 PSI is not too high for many vehicles; it's often within the recommended range of 30-35 PSI for passenger cars. The correct tire pressure is specific to your vehicle, so you should always check the recommended PSI on the sticker inside your driver's side doorjamb or in your owner's manual, rather than a generic guideline. Running at the correct pressure ensures optimal handling, safety, and tire life, while overinflating or underinflating can lead to uneven wear and other problems.
 
How to find your vehicle's recommended tire pressure

• Look for the sticker: Find the sticker on the driver's side doorjamb. It will list the recommended "cold" tire pressure (PSI) for your front and rear tires. 
• Check your owner's manual: If you can't find the sticker, look in your vehicle's owner's manual for the correct PSI information. 
• Inflate when cold: Check and adjust your tire pressure when the tires are "cold," meaning the vehicle hasn't been driven for at least a few hours. This is because driving heats up the tires and increases the pressure. 

Why correct tire pressure is important

• Safety and performance: Proper inflation ensures good handling, braking, and overall vehicle control.
• Fuel efficiency: Correctly inflated tires can improve your gas mileage.
• Even tire wear: Maintaining the right pressure helps your tires wear down evenly, extending their lifespan. 

What happens if you overinflate

• Harsh ride: Overinflated tires can lead to a stiffer, bumpier ride. 
• Reduced traction: A smaller contact patch between the tire and the road can decrease grip, especially in wet conditions. 
• Increased risk of blowout: While many modern tires can handle high PSI, overinflation can increase the risk of a blowout, particularly if you hit a pothole. 

What is the PSI for Acura tires?

between 32-36 PSI
As a rule of thumb, tire pressure should usually be between 32-36 PSI. Check your owner's manual for exact numbers, as these can vary from model to model.