What oil does a 2007 Ford Freestar take?
The 2007 Ford Freestar typically uses 5W-20 motor oil that meets Ford’s specifications, with about 5 quarts needed for a full change. You can use conventional, synthetic blend, or full synthetic oil as long as it meets the proper Ford standard. Always confirm the exact requirement for your specific engine and climate by checking the owner’s manual or the under-hood label.
Engine and oil basics for 2007 Freestar
The 2007 Freestar was widely equipped with a 4.2-liter V6 Duratec engine. For most configurations in this year, Ford’s maintenance guidance points to using 5W-20 oil to ensure proper lubrication under typical driving conditions. If you’re unsure of your exact engine variant, verify the specification on the vehicle’s label or in the owner’s manual.
- 4.2L V6 Duratec engine (the common configuration for 2007 Freestar models).
Bottom line: stick with 5W-20 oil and ensure it meets Ford’s specification for your engine variant.
Oil grade and capacity details
Viscosity and specification are the key criteria for the Freestar’s oil. The following guidelines help you choose the right product and understand capacity.
- Viscosity: 5W-20 (SAE)
- Oil type: Conventional, synthetic blend, or full synthetic are acceptable as long as they meet Ford’s specification.
- Specification: Ford WSS-M2C930-A (or newer equivalent) or API SN/SP grade oils that are listed as suitable for Ford engines
- Capacity: Approximately 5 quarts (with filter); exact capacity depends on your engine variant and whether the filter is included
Always verify the exact capacity for your vehicle on the under-hood oil fill label or in the owner’s manual, since variations can occur by engine configuration.
How to verify the right oil for your vehicle
Because production runs and regional variants can affect the exact spec, use these steps to confirm the correct oil for your Freestar:
- Check the owner’s manual section on engine oil for the recommended viscosity and specification.
- Look at the under-hood oil fill cap or a vehicle information sticker near the engine bay for the recommended oil type and capacity.
- If you’re unsure, contact a Ford dealer or service center with your VIN to confirm the exact engine variant and oil specification.
Following these steps helps ensure you’re using the correct oil for your exact Freestar configuration and climate.
Summary
For the 2007 Ford Freestar, the standard recommendation is 5W-20 motor oil that meets Ford specifications (typically WSS-M2C930-A or newer). The approximate oil capacity is about 5 quarts with a filter. You may use conventional, synthetic blend, or full synthetic oil, but always verify the precise specification and capacity for your engine variant via the owner’s manual or a dealer, especially if your model has a different engine configuration or operates in extreme conditions.
