Where is the fuel pump on a 2007 Toyota Camry?
The fuel pump on a 2007 Toyota Camry is located inside the fuel tank (in-tank), not in the engine bay. Access to the pump is gained through a service panel beneath the rear seat cushion. This setup is standard for the XV30 Camry generation, though exact access steps can vary by trim.
Location and access
The Camry’s in-tank fuel pump sits securely inside the fuel tank. To reach it for inspection or replacement, you typically remove the rear seat bottom cushion to expose a circular access panel on top of the tank. Depending on the trim, you may need to move or remove some interior trim to gain clear access to that panel. The pump module is held in place by a locking ring or bolts, and it connects to an electrical harness and fuel lines that must be carefully disconnected during service.
If you’re planning to inspect or replace the pump, here is a concise step-by-step guide.
- Disconnect the negative battery terminal to prevent sparks and relieve any residual fuel pressure by removing the appropriate fuse and starting the engine until it stalls.
- Remove the rear seat bottom cushion (and, if required, any trim pieces) to reveal the fuel-tank access panel.
- Uncover and remove the access panel on top of the fuel tank. Use the proper tool to loosen the locking ring or mounting screws securing the pump module.
- Disconnect the electrical connector and carefully detach the fuel lines from the pump module, noting their positions for reassembly.
- Lift the pump assembly out of the tank, taking care not to damage the O-ring seal. Inspect the seal and surrounding areas for wear or cracks.
- Install a replacement pump or serviceable unit, re-seal with a new O-ring, and lower the module back into the tank. Reinstall the locking ring or bolts securely.
- Reconnect the electrical connector and fuel lines, ensuring all clamps are tight and secure.
- Reinstall the access panel and any interior trim, then reposition the rear seat cushion.
- Reconnect the battery, turn the ignition to ON for a few seconds to prime the fuel system, and start the engine to verify proper operation and check for leaks.
Concluding: This is the standard procedure for accessing and servicing the fuel pump on a 2007 Camry. If you are unsure or uncomfortable performing fuel-system work, consult a qualified technician to avoid safety hazards.
Summary
In summary, the 2007 Toyota Camry stores its fuel pump inside the fuel tank and provides access through a panel under the rear seat cushion. Replacement involves depressurizing the system, removing the pump module via the access panel, and resealing on reinstallation. Always prioritize safety and consider professional service if you lack experience with fuel systems.
