Loading

How much oil does a 04 Acura TL take?


As a seasoned auto service provider, I often get questions about oil capacities for specific vehicles. Knowing the correct oil capacity is crucial for maintaining your car's engine health and ensuring optimal performance. In this article, I’ll provide a detailed answer to the question: How much oil does a 2004 Acura TL take?


Oil Capacity for the 2004 Acura TL


The 2004 Acura TL, equipped with a 3.2L V6 engine, has a specific oil capacity depending on whether you are performing a standard oil change or including a filter replacement. Here’s the breakdown:



  • With an oil filter change: The engine requires approximately 4.5 quarts (4.3 liters) of oil.

  • Without an oil filter change: The engine takes slightly less, around 4.2 quarts (4.0 liters).


It’s always a good idea to check your owner’s manual for the most accurate information, as variations can occur based on specific trim levels or modifications.


Recommended Oil Type


For the 2004 Acura TL, Honda recommends using 5W-20 motor oil. This oil type ensures proper lubrication and performance under a wide range of temperatures. You can choose between conventional, synthetic blend, or full synthetic oil, but full synthetic is often preferred for its superior performance and longevity.


Steps to Check Your Oil Level


After adding oil, it’s essential to verify the oil level to avoid overfilling or underfilling. Follow these steps:



  • Park your car on a level surface and turn off the engine. Wait a few minutes to allow the oil to settle.

  • Locate the dipstick, usually marked with a bright handle, and pull it out.

  • Wipe the dipstick clean with a cloth or paper towel.

  • Reinsert the dipstick fully, then pull it out again to check the oil level.

  • Ensure the oil level is within the marked range on the dipstick. Add more oil if necessary, but do not overfill.


Why Proper Oil Levels Matter


Maintaining the correct oil level is critical for several reasons:



  • Engine Protection: Oil lubricates engine components, reducing friction and preventing wear.

  • Temperature Regulation: Oil helps dissipate heat, keeping the engine cool.

  • Fuel Efficiency: Proper lubrication ensures the engine runs smoothly, improving fuel economy.

  • Longevity: Regular oil changes and maintaining the correct oil level extend the life of your engine.


Conclusion


For a 2004 Acura TL, the oil capacity is approximately 4.5 quarts with a filter change, and 4.2 quarts without. Always use 5W-20 motor oil for optimal performance, and double-check your oil level after filling. If you’re unsure

Frequently Asked Questions

How much oil does a 2004 Acura take?


Oil Grade: API*

Viscosity:5W-20, 0W-20 (All TEMPS) - Acura Engine Oil Application Guide (Rev. 12/1/11) indicates that 0W-20 is acceptable to use in this application.
Capacity:4.2 quarts. w/of. After refill check oil level.
Capacity:4.5 quarts (with filter). After refill check oil level.
Torque:29 ft/lbs (Oil Drain Plug)



How much oil does a 2.4 l Acura take?


Oil Grade: API*
Capacity: 4.6 quarts (with filter).



What kind of oil does a Acura TL 3.7 take?


AMSOIL 5W-20 100% Synthetic High-Mileage Motor Oil.



How much oil does a 2004 Alto take?


Engine Oil SUZUKI ALTO VI (FF) 1.1 (RF410) (63 Hp) 2004 - 2008. The quantity needed to change the oil in your engine is 4,0 litres.



How much oil does a 2.4 L 4 cylinder engine take?


4.5 quarts
4.5 quarts (with filter). After refill check oil level.



How many quarts of oil does a 3.5 L take?


6.0 qt
Capacities and Specifications - 3.5L Ecoboost

ItemCapacity
Engine oil (with oil filter)6.0 qt (5.7 L)
Engine coolant13.1 qt (12.4 L)
Brake fluidBetween MIN/MAX on brake fluid reservoir
Rear axle fluid (four-wheel drive)2.11 pt (1.0 L)



How much oil does a 2.4 L 4 cylinder Honda take?


4.2 quarts. w/of. After refill check oil level.



How much oil does a 4 cylinder Alto take?


3 litres of Engine Oil is required for Maruti Alto.



How much oil for a 2004 Acura TL?


Oil Grade: API*

Viscosity:5W-20, 0W-20 (All TEMPS) - Acura Engine Oil Application Guide (Rev. 12/1/11) indicates that 0W-20 is acceptable to use in this application.
Capacity:4.2 quarts. w/of. After refill check oil level.
Capacity:4.5 quarts (with filter). After refill check oil level.
Torque:29 ft/lbs (Oil Drain Plug)



How much oil does a 3.5 l Acura TL take?


Fill the oil, just shy of an entire five quart bottle, as the TL uses 4.5 quarts total. Remove the oil drain pan from under the vehicle if not done so already. Take the vehicle down off the jack stands. Start the vehicle and let it run for several minutes.


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.