How much oil does a 2018 Ford Transit 350 take?

Most 2018 Ford Transit 350 models use about 6 quarts of engine oil with a filter, though diesel variants can require closer to 8 quarts. The exact capacity depends on the engine option installed in the vehicle.

Engine options available in the 2018 Transit 350

The Transit 350 could be equipped with several powertrains. The oil capacity varies by engine type, so it’s important to match the number to your specific engine.

Use the following guide to match the oil capacity to your exact engine configuration.

• 3.7L Ti-VCT V6 gasoline engine: approximately 6 quarts (5.7 L) of engine oil with the filter installed.


• 3.5L EcoBoost V6 gasoline engine: approximately 6 quarts (5.7 L) of engine oil with the filter installed.


• 3.2L Duratorq diesel engine (availability varies by market): approximately 8 quarts (7.5 L) of engine oil with the filter installed.

Note: These figures are typical capacities and can vary by vehicle options and market. Always verify the exact oil capacity for your specific VIN in the owner's manual or on the engine oil filler cap.

Practical tips for checking and changing oil

To keep your Transit 350’s engine healthy, follow these steps for checking and changing oil. The steps assume you are using the correct oil specification for your engine and that you follow any local maintenance guidelines.

Before you begin the step-by-step process, prepare your work area and gather the necessary tools and supplies.

1. Park on a level surface, engine off, and apply the parking brake. If the engine was recently run, allow it to cool for a few minutes.


2. For checking oil level, locate the dipstick, remove it, wipe clean, reinsert fully, then pull it out again to read the current level.


3. If you are performing an oil change, drain the old oil into a suitable container, replace the oil filter, and reinstall the drain plug securely.


4. Fill with the recommended oil type and quantity for your engine, then recheck the level with the dipstick to ensure it is within the proper range.


5. Dispose of used oil and filter in accordance with local environmental regulations. Reset any maintenance reminders if applicable.

Regular oil changes with the correct oil type and capacity help protect engine components and maintain performance and efficiency.

Summary

The 2018 Ford Transit 350’s oil capacity depends on the engine installed. Gasoline versions (3.7L Ti-VCT V6 and 3.5L EcoBoost V6) typically require about 6 quarts of oil with a filter, while the diesel 3.2L Duratorq option may require around 8 quarts. Always confirm the exact capacity for your vehicle using the owner's manual or the information under the hood, and follow proper procedures when checking or changing oil to keep the engine running smoothly.

What oil does a Ford Transit 350 use?

Can't generate an AI overview right now. Try again later.

What kind of oil does a 2018 Ford Transit take?

The 2018 Ford Transit typically uses 5W-20 or 5W-30 full synthetic or synthetic blend motor oil, depending on the specific engine. The 3.5L V6 engine often uses 5W-20, while other models might use 5W-30. It is crucial to check the owner's manual or the vehicle's oil filler cap for the exact recommendation, which may also be affected by the vehicle's mileage and climate.
 
Oil recommendations by engine size

• 3.5L V6: Often uses 5W-20 synthetic or synthetic blend oil. 
• 3.7L V6: Often uses 5W-20 oil. 
• Other engines: Depending on the specific engine, the recommended oil could be 5W-20 or 5W-30. Some high-mileage models might have specific recommendations. 

Other considerations

• Oil type: The vehicle may require full synthetic or synthetic blend oil for optimal performance and protection. 
• Mileage: Vehicles with over 75,000 miles may benefit from high-mileage oil formulations. 
• Check the manual: The most accurate oil type and weight can be found in the owner's manual or on the vehicle's oil filler cap. 
• Diesel engines: If your model is a diesel, it will have different oil requirements, such as a 5W-40 or 15W-40 synthetic oil. 

How many quarts of oil does a 2018 Ford Transit 350 take?

Engine Oil
Capacity: 6 quarts (with filter).

How many quarts of oil does a 6.7 l diesel take?

The 6.7 diesel oil capacity varies by model and year. For 2023+ Ford Super Duty models, it's 15 quarts (14.2 L). However, for 2011–2022 models, the capacity is typically 13 quarts (12.3 L). It is always best to check your specific owner's manual for the most accurate information. 

• 2023 and newer Ford Super Duty (F-250 to F-600): 15 quarts (14.2 L) 
• 2011–2022 Ford Super Duty (F-250 to F-600): 13 quarts (12.3 L) 
• Ford F-650 and F-750 (2015–2022): Up to 15 quarts (14.2 L) 
• Ford F-650 and F-750 (2023+): 17 quarts (16.1 L) 

Important: Always verify the capacity in your owner's manual, as capacities can change based on the specific vehicle and year. Overfilling can cause engine damage, so it's crucial to fill to the correct level.