How much oil does a Ford Galaxy 2.0 TDCi take?
About 5.0 liters (roughly 5.3 quarts) of engine oil, including the oil filter, for a full oil change on most Ford Galaxy 2.0 TDCi engines.
The exact capacity depends on the engine code and model year, with typical figures ranging from around 4.5 to 5.0 liters. For the precise specification, consult the owner's manual or Ford's service documentation for your VIN.
Oil capacity in practice
Oil capacity varies slightly by engine variant and whether the filter is replaced. The figures below reflect common references for the Galaxy's 2.0 TDCi family and should be used as a guide alongside official documentation.
- Typical overall capacity for a full change (oil plus filter): about 5.0 L.
- Some engine variants and model years may sit closer to 4.5–4.8 L; confirm for your exact configuration.
- Capacities can vary by market and year; always verify with the manual or Ford’s official documentation for your VIN.
When performing an oil change, use the dipstick to verify the level after adding oil and top up gradually until the level is at the correct mark on a level surface with the engine off and cooled.
How to verify the exact capacity for your Galaxy
Because two 2.0 TDCi variants exist in the Galaxy lineup, the reliable way to confirm your precise figure is to consult official documentation for your VIN and engine code. The steps below outline a practical approach.
- Locate your vehicle Identification Number (VIN) and engine code from the dash, insurance documents, or door jamb plaque.
- Check the owner's manual or Ford’s online service portal for the exact oil capacity and filter change guidance for that engine code.
- During an oil change, drain old oil, replace the filter, and add oil in small increments up to the recommended capacity.
- Run the engine briefly, switch off, wait for oil to settle, then recheck with the dipstick and top up to the correct level if needed.
Following these steps ensures you use the correct amount of oil for your specific Galaxy model and engine code.
Summary
The Ford Galaxy 2.0 TDCi typically requires about 5.0 liters of engine oil for a full change, including the filter, but exact capacity varies by engine code and year. Always confirm with the owner's manual or Ford service documentation for your VIN, and verify the final level with the dipstick after topping up.
What kind of oil does a 2016 Ford Focus 2.0 TDCi take?
Only use fluid that meets Ford specifications. If you are unable to find an engine oil that meets the specification defined by WSS-M2C950-A, it is acceptable to use a SAE 5W-30 engine oil that is defined by ACEA A5/B5.
How many quarts of oil does a 2.0 Ford motor take?
6.1 quarts
Engine Oil
6.1 quarts (with filter).
What kind of oil does a Ford Galaxy 2.0 TDCi take?
6 Litres Of Castrol 5W30 Engine Oil.
How much oil to put in a 2.0 TDI?
4.5 quarts
Fill the engine with 4.3 liters or 4.5 quarts of engine oil that carries the VW 507 00 oil specification.
