How much oil does an Acura TL take?
The Acura TL typically takes between 4.5 and 5.1 quarts of engine oil, depending on the model year and engine. Older TLs with the 3.2L V6 use about 4.5 quarts with a filter, while later 3.5L V6 models require about 5.1 quarts. This article breaks down the capacity by generation to help you plan changes accurately.
The following reference summarizes typical oil capacities for each TL generation. Note that exact amounts can vary slightly with engine version and chosen oil filter.
- 1999–2003 Acura TL (1st generation) — 4.5 quarts (4.3 L) of oil with the filter
- 2004–2008 Acura TL (2nd generation) — 4.5 quarts (4.3 L) of oil with the filter
- 2009–2014 Acura TL (3rd generation) — 5.1 quarts (4.8 L) of oil with the filter
These figures serve as a baseline for routine oil changes. Always account for the filter and any drain-back variance, and confirm the final fill with the dipstick after a change.
Generation-by-Generation Details
First generation TL (1999–2003) — 3.2L V6
The 1999–2003 TL uses a 3.2-liter V6. Its oil capacity is typically listed as 4.5 quarts (4.3 liters) with the filter. This generation generally followed the then-standard practice of using about 4.5 quarts during a full oil change, plus the new oil filter. Viscosity recommendations commonly align with 5W-30 under normal conditions, but always verify based on your climate and the owner's manual.
Second generation TL (2004–2008) — 3.2L V6
The 2004–2008 TL maintains the 3.2-liter V6 configuration and uses a similar oil capacity: around 4.5 quarts (4.3 liters) with the filter. As with the first generation, refer to the manual for the exact grade and any regional recommendations. The swap to a new generation did not significantly change the stated capacity for this engine family.
Third generation TL (2009–2014) — 3.5L V6
The 2009–2014 TL shifts to a 3.5-liter V6, and oil capacity increases to about 5.1 quarts (4.8 liters) with the filter. This larger-capacity engine requires careful topping off and a full oil change to reach the proper level. The recommended oil grade is typically around 5W-20, though your manual may specify alternatives for certain climates; always confirm with the owner's guide.
Oil Grade and Maintenance Tips
While capacity is the primary concern for planning changes, using the correct oil grade is crucial for protection and efficiency. Most TLs have historically used 5W-20 or 5W-30 as a standard specification, depending on year and climate. Always check the vehicle’s owner’s manual or the under-hood sticker for the exact grade, and ensure you replace the oil filter during every change. After draining, add oil gradually and recheck with the dipstick to avoid overfilling.
Summary
In short, the Acura TL’s oil capacity depends on the generation: about 4.5 quarts for the 1999–2008 3.2L V6 models, and about 5.1 quarts for the 2009–2014 3.5L V6 models. Always verify against your specific vehicle’s manual and use the correct oil grade for your climate. A careful fill and dipstick check will ensure you maintain proper engine lubrication.
How many quarts of oil does a 3.6 L V6 take?
A 3.6L V6 engine typically takes between 5 and 6 quarts of oil, but the exact amount varies by vehicle model, so you must check your owner's manual or the oil fill cap for the precise capacity. For example, some models like a 2013 Jeep JK require 6 quarts, while newer models like a 2020 Jeep Wrangler or 2018+ Jeep Wrangler JL may only take 5 quarts.
Here are some general guidelines:
- Check your owner's manual: This is the most reliable source for your specific vehicle.
- Look at the oil fill cap: It may have the required viscosity and capacity printed on it.
- Consider the model year: Newer vehicles, especially certain Jeep models, have different oil capacities than older ones.
- Change the oil filter: Always include an oil filter change, as this is part of the full oil capacity.
- After refilling, check the level: After you've filled the engine with oil, use the dipstick to check the oil level and add more if needed to reach the "full" line.
How much oil does a 2008 Acura TL V6 take?
5Qts Genuine Acura Full Synthetic Engine Oil 5w20. 2006-2008 Acura TL 3.2L V6.
How many quarts of oil does an Acura TL take?
The oil capacity for an Acura TL depends on the model year, but most recent models require about 4.5 quarts of oil with a filter change. For older models, the capacity may be slightly different, for example, the 2002 model requires 4.6 quarts, while the 2001 model requires 4.6 quarts as well. It is always best to confirm your specific model year's requirements and check the dipstick after refilling.
Examples of Acura TL oil capacities
- 2002 Acura TL: 4.6 quarts
- 2008 Acura TL (3.2L): 4.5 quarts
- 2009 Acura TL (3.5L): 4.5 quarts
- 2010 Acura TL (3.5L): 4.5 quarts
- 2010 Acura TL (3.7L): 4.5 quarts
- 2012 Acura TL (3.5L): 4.5 quarts
Important considerations
- Check the dipstick: After adding oil, run the engine for a few minutes, then turn it off and check the dipstick to ensure the level is correct. Overfilling can damage the engine.
- Replace the filter: Always replace the oil filter during an oil change for proper lubrication.
- Consult your manual: For the most accurate information for your specific vehicle, always refer to your owner's manual.
How much oil does a 2.3 4 cylinder take?
It.
