How much transmission fluid does a 2010 Chevy Impala 3.5 take?
The 2010 Chevy Impala 3.5 takes approximately 3.5 quarts of transmission fluid. This is the standard amount required for this specific model and engine configuration. The exact amount may vary slightly depending on factors such as the transmission type and any modifications made to the vehicle.
Detailed Breakdown
The 2010 Chevy Impala 3.5 is equipped with a 3.5-liter V6 engine and a 4-speed automatic transmission. According to the vehicle's owner's manual and various automotive repair guides, the recommended transmission fluid capacity for this model is 3.5 quarts.
It's important to use the correct type of transmission fluid specified by the manufacturer, which in this case is a Dexron-VI or equivalent fluid. Using the wrong fluid can lead to transmission problems and decreased performance.
Checking and Changing Transmission Fluid
- To check the transmission fluid level, the vehicle should be parked on a level surface with the engine running and the transmission in Park.
- The fluid level should be checked using the dipstick, which is typically located near the front of the transmission.
- If the fluid level is low, it should be topped up with the recommended fluid until it reaches the full mark on the dipstick.
- Transmission fluid should be changed at regular intervals, typically every 30,000 to 60,000 miles, or as specified in the owner's manual.
Proper maintenance of the transmission fluid is crucial for the longevity and smooth operation of the 2010 Chevy Impala 3.5's transmission. Following the manufacturer's recommendations and using the correct fluid type will help ensure the vehicle's transmission functions as intended.
How much is transmission fluid capacity?
Vehicles require an average of 4 to 17 US gallons (3.8 to 16 liters) of transmission fluid to fill; the majority of automobiles contain between 12 and 16 quarts (11.3 to 15.1 liters), depending on the car's manufacture and other criteria.
How do I know how much transmission fluid I need?
Remove the dipstick. The tip should be covered in transmission fluid all the way to the FULL indicator line. If the fluid level is low — meaning it doesn't rise to the FULL indicator line — you can just top it off.
How many quarts of transmission fluid does a 2008 Chevy Impala hold?
7.4 quarts
The repair manual says that roughly 7.4 quarts will be needed after replacing the filter and sensors in the transmission.
How much transmission fluid does a 2009 Chevy Impala 3.5 take?
Automatic Transmission Fluid
7.4 quarts Initial Fill.
How much transmission fluid does a 2010 Chevy Impala hold?
Amsoil.com says initial fill for the transmission is 7.4 quarts with total capacity being 13.4 quarts.
Is 4 quarts of transmission fluid enough?
You might need 3 to 5 quarts of fluid for a standard automatic transmission car.
How much transmission fluid does a 2008 Chevy Impala take?
7.4 quarts
The repair manual says that roughly 7.4 quarts will be needed after replacing the filter and sensors in the transmission.
How many quarts of transmission fluid do I need for a change?
Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.
How many quarts does a 3.5 impala take?
4 quarts
4 quarts (with filter). After refill check oil level.
How many quarts does a 3.5 V6 hold?
It's 6.1 if you do an oil and filter change, 5.8 if you do just an oil change. Most of us just put in 6 and this will get you an oil level on the high side of the dip stick high/low level marks.
