How many quarts of transmission fluid does a 2016 Honda HR-V take?
In brief: The 2016 HR-V's CVT holds about 7 quarts of transmission fluid in total, and a typical drain-and-fill service replaces roughly 4–5 quarts. Use Honda HCF-2 CVT fluid and follow the manufacturer’s level-check procedure for accuracy.
The 2016 Honda HR-V uses a continuously variable transmission (CVT) that requires the correct CVT fluid (Honda HCF-2). Total capacity, and how much you replace during service, depends on whether you perform a partial drain-and-fill or a full flush, and on whether the vehicle is front-wheel drive (FWD) or all-wheel drive (AWD). This article outlines the typical capacities and practical implications for maintenance.
Transmission fluid capacity and service options
Below are typical figures to guide maintenance planning. Exact amounts can vary slightly by model, production batch, and service method. Always verify with the owner's manual or Honda service information if possible.
- Total system capacity (CVT): approximately 7.0–7.5 quarts
- Drain-and-fill volume (fluid replaced during a standard service): about 4–5 quarts
- Full flush capacity (if performing a complete system refresh with proper equipment): up to the total capacity, around 7.0–7.5 quarts
Note: The exact amount depends on whether the HR-V is FWD or AWD and on the specific service method used. CVTs require the correct specification of fluid (Honda HCF-2) and careful level checking with the proper procedure after service.
Notes by drivetrain and service method
All-wheel-drive models can have small variations in capacity, but the general range above remains close. If you are unsure, consult the owner's manual or a Honda dealer for the precise specification for your exact VIN and model variant.
After any CVT fluid service, reset the maintenance indicators if applicable and perform the level check according to Honda's procedure, since CVT fluid levels are checked differently than conventional ATFs.
Summary
The 2016 Honda HR-V with CVT uses roughly 7 quarts of CVT fluid in total, with about 4–5 quarts replaced during a standard drain-and-fill. For a full flush, plan to use up to the full 7–7.5 quarts. Always use Honda HCF-2 CVT fluid and follow the official level-check procedure for best results.
