How much oil does a Subaru Tribeca h6 take?
The Subaru Tribeca H6 engine requires 5.1 quarts (4.8 liters) of oil for a standard oil change. This includes the oil filter replacement. The Tribeca's H6 boxer engine is a 3.6-liter six-cylinder engine that needs regular maintenance and oil changes to keep it running smoothly.
Subaru Tribeca H6 Engine Oil Capacity
The Subaru Tribeca is equipped with a 3.6-liter H6 (horizontally-opposed six-cylinder) engine. This engine has the following oil capacity specifications:
- Oil capacity (with filter): 5.1 quarts (4.8 liters)
- Oil capacity (without filter): 4.9 quarts (4.6 liters)
It's important to use the recommended oil type and viscosity grade for your Tribeca's engine. Subaru specifies 5W-30 synthetic oil for the H6 engine.
Oil Change Procedure for Subaru Tribeca H6
To change the oil in a Subaru Tribeca H6, you'll need to:
- Park the vehicle on a level surface and apply the parking brake.
- Locate the oil drain plug, usually on the bottom of the oil pan, and place a drain pan underneath.
- Unscrew the drain plug and allow the old oil to fully drain out.
- Once drained, replace the drain plug and tighten it securely.
- Locate the oil filter, usually accessible from the top of the engine, and use an oil filter wrench to remove it.
- Apply a thin coat of new oil to the gasket of the new oil filter, then screw it on by hand until secure.
- Unscrew the oil fill cap and pour in 5.1 quarts (4.8 liters) of the recommended 5W-30 synthetic oil.
- Replace the oil fill cap and start the engine, checking for any leaks.
- Allow the engine to run for a few minutes, then check the oil level using the dipstick. Top up if necessary.
Be sure to dispose of the old oil and filter properly. Regular oil changes are essential for maintaining the health and longevity of your Subaru Tribeca's H6 engine.
Is it OK to use 5W 20 instead of 0W-20?
If SAE 0W-20 synthetic oil is not available, SAE 5W-20 conventional oil may be used. However, it must be replaced with SAE 0W-20 synthetic oil at the next oil change.
How many quarts of oil does my Subaru take?
Subaru Oil Guide:
| Model | Subaru Oil Required | Capacity |
|---|---|---|
| Subaru Legacy & Outback 6 Cyl. 2002 - 2019 | 5W-30 Conventional Oil | 6 - 6.9 Quarts |
| Subaru Legacy & Outback XT (Turbo) 2020 - 2021 | 0W-20 Synthetic Oil | 4.8 Quarts |
| Subaru WRX 2002 - 2010 | 5W-30 Conventional Oil | 4.4 - 5 Quarts |
| Subaru WRX 2011 - 2020 | 5W-30 Synthetic Oil | 4.4 - 5.4 Quarts |
How many quarts does a 2.5 L engine take?
Capacities and Specifications - 2.5L
| Item | Capacity |
|---|---|
| Engine oil (with oil filter). | 5.7 qt (5.4 L) |
| Engine coolant. | 7.2 qt (6.8 L) |
| Brake fluid. | Between MIN/MAX on brake fluid reservoir |
| Automatic transmission fluid.* | 9.0 qt (8.5 L) |
How much oil does a 2.5 L Subaru engine take?
5.1 quarts
In this automobile, the oil capacity depends on which type of engine you have. For the 2.5L 4-cylinder engine, the capacity is 5.1 quarts; for the 3.6L 6-cylinder engine, the capacity is 6.9 quarts.
How many miles will a Subaru Tribeca go?
While results will vary and the big variable is always how well the car has been maintained, what I can tell you is a Subaru is capable of going 300,000 miles. And if you are a regular maintenance type of owner you should expect to get that type of mileage out of it.
What engine is H6?
Subaru has marketed its flat-four and flat-six engines as "H4" and "H6" respectively. The letter "H" in this case refers to "horizontally-opposed", an alternative term for flat engines; these engines can also be said to look like a "H" or conjoined "H"s, albeit from the top and in schematic form.
How many quarts of oil does a Subaru Tribeca take?
Oil Grade: SM
5W-30 (All TEMPS) - SAE 5W-30 is preferred. Capacity: 6.9 quarts (with filter).
What happens if I use 0w20 instead of 5w30?
Can I use a 0W-20 in my car that recommends 5W-30? No, if your owner's manual calls for a thicker oil, you should not use a thinner SAE grade nor use a thicker oil for a recommended thinner oil vis-grade. Using the proper viscosity motor oil will help protect and maintain the performance of your vehicle's engine.
How much oil does a Subaru H6 take?
6 quarts (with filter).
Why does Subaru use 0W-20 oil?
The 0W-20 is the perfect weight for he non-turbo engine and is formulated for improved fuel economy.
